Parallelogram Image Adjustment
Do the following procedure if a parallelogram prints while adjusting the printing registration or printing
margin using the trim pattern.
The following procedure should be done after adjusting the side-to-side registration for each paper tray
station. Use SP2902-010 (Print T Pattern – Trim Area) to determine whether a parallelogram image ap-
pears. If the parallelogram pattern appears, perform the following procedure.
1. Laser unit [A]
2. Bracket [B] ( x2)
3. Install adjustment cam [C] (P/N: A2309003)
4. Secure positioning pin [D] (P/N A2309004) with the two screws removed with the bracket
[B]. Do not tighten the screws at this time.
5. To adjust the position of the laser unit [E]
Parallelogram Image Adjustment
145
To Next Page
Loading...
