2. If the surfaces of the tapes do not show “VOID”, remove them from the corners of the box.
• If you see “VOID” on the tapes, do not install the components in the box. Stop the procedure
and contact your Sales Division.
3. When you remove each seal, the “VOID” marks [2] can be seen. In this condition, they
cannot be attached to the box again.
Installation Procedure: DOS Unit
• The DOS SD card must be inserted in SD card slot C1. Make sure that the Data Overwrite Security
Option B735 is "Type C".
1. Installation
44
To Next Page
Loading...
