6. Go into the SP mode and select SP5873 001.
7. Push [#Enter].
8. Read the instruction on the display then push [#Enter] to start copying.
9. When the display tells you copying is completed, push [#Enter].
10. Turn the machine off.
11. Remove the Source SD card from C3. Leave the target SD card in C1.
12. Turn the machine on.
13. Confirm that the SD card applications have been enabled:
• Push [Menu] then select "List/Test Print"> "Config. Page" to print the configuration page.
14. Turn the machine off again, then:
• Attach the SD card slot cover.
• Tape the copied source card to the faceplate of the controller box.
• Attach the rear cover of the machine.
• After an SD card is copied, it cannot be used. But it must be stored at the customer site, to serve as
proof of purchase by the customer.
• The original card can also be used to perform an undo procedure (SP 5873 002). Before you tape
the copied SD card to the machine, label it carefully so that you can identify it easily if you need to
do the undo procedure at a later time (see ‘Undo Exec’).
Undo Merging
1. Turn the main switch off.
2. Put the SD card with the merged applications in C1.
3. Insert the original destination SD card (the one taped to the faceplate of the controller box)
into C3.
• The SD card in C3 must be the original SD card of the application you want to move from C1
to C3. You cannot use any blank SD card in C3.
4. Turn the main switch on.
5. Go into the SP mode and do SP5873-002 (Undo Exec)
6. Follow the messages on the operation panel to complete the procedure.
7. Turn the main switch off.
8. Remove the SD cards from the slots.
9. Turn the main switch on.
Controller Options
51
To Next Page
Loading...
