Acronym Meaning
ECS Engine Control Service
GPS GW Print Service
GSP-PM GW Print Service – Print Module
IMH Image Memory Handler
MCS Memory Control Service
NCS Network Control Service
NFA Net File Application
PDL Printer Design Language
PTS Print Server
SCS System Control Service
SRM System Resource Management
WebDB Web Document Box (Document Server)
The machine is now set to record the debugging information automatically on the SD card or HDD (the
target selected with SP5857-002) for the events that you selected SP5858 and the memory modules
selected with SP5859.
Please keep the following important points in mind when you are doing this setting:
• The initial settings are all zero.
• These settings remain in effect until you change them. Be sure to check all the settings, especially the
settings for Keys 6 to 10. To switch off a key setting, enter a zero for that key.
• You can select any number of keys from 1 to 10 (or all) by entering the corresponding 4-digit numbers
from the table.
• One area of the disk is reserved to store the debug log. The size of this area is limited to 4 MB.
Retrieving the Debug Log from the HDD
1. Insert the SD card into service slot C3.
2. Enter the SP mode and execute SP5857 009 (HDD for SD (4MB)) to write the debugging
data to the SD card.
3. Use a card reader to copy the file and send it for analysis to your local Ricoh representative
by email, or just send the SD card by mail.
Using Debug Log
297
To Next Page
Loading...
