By-Pass Tray Unit
Use this procedure to remove the complete by-pass tray unit from the machine. If you wish to remove only
the table, or some of the components of this unit, see ‘By-Pass Tray’.
1. Duplex unit (See ‘Duplex Unit’.)
2. Left cover [A] ( x1)
3. Right cover [B] ( x1)
4. Connectors [C] ( x2)
5. By-pass unit [D] ( x4)
• After removing the screws, lift to unhook the by-pass tray unit from the frame of the machine.
Covers and Common Procedures
69
To Next Page
Loading...
