Ricoh A-P4 - SP5804 Output Check Table

Output Check
• Motors keep turning in this mode regardless of upper or lower limit sensor signals. To prevent me-
chanical or electrical damage, do not keep an electrical component on for a long time.
Enter the SP mode and select SP5804.
1. Press  together (for 5 seconds), release, then press [#Enter].
System Ver.1.00
1. Service
2. Press .
System Ver. 1.00
2. Engine
3. Press [#Enter].
<Engine>
1. Feed
4. Press  to display “5. Mode”.
<Engine>
5. Mode
5. Press [#Enter].
SP5024
mm/inch Display
6. Press  repeatedly to display “Output Check”.
SP5804 >>
Output Check
7. Press [#Enter].
SP5804-001
1st.PaperFeedCl.
8. Press  or  to display the item to check.
SP5804-027
5. Service Tables
270
5