• Press to return to the previous level.
To change a multiple-digit number setting
• Press or to move the cursor to the digit that you want to change.
• Press [#Enter]. A number replaces the cursor.
• Press or to increase or decrease the number.
• Press [#Enter]. The number selected on the 2nd line replaces the number above.
• Repeat the procedure to enter numbers for the other digits.
• Press #(Escape) to return to the previous level.
To select an item from a list
• The current selection is marked with a large asterisk ().
• Press or to display on the 2nd line the item to select.
• With the item that you want to select displayed on the second line, press [#Enter]. The selected
item is marked with an asterisk.
• Press [Escape] to return to the previous level.
Leaving the SP Mode
1. When you are finished with SP selection, press [Escape] until you see “2.Engine”.
2. Press to display “3.End”.
3. Press [#Enter] to display “Offline”.
4. Press [Online] to set the printer online.
• Powering the printer off and on leaves the SP mode, and returns the printer online in normal
operation mode.
Service Program Mode Operation
185
To Next Page
Loading...
