Operation Panel
• The fusing unit below the cover is hot. Allow the machine to cool for 10 minutes before you begin the
procedure.
1. Fusing unit cover [A] (caps x 2, x 2)
Insert the tip of a screwdriver into the slot to release the plastic hook and lift. Exert very little pressure
to avoid breaking the hooks.
2. After removing the screws, slide cover [B] forward to remove it.
Before re-installing the cover, open the duplex unit and carefully insert the brackets on the bottom of
the cover into the slots [C].
3. Operation panel [D] ( x 2, x 2)
Turn over the fusing unit cover and pull off the operation panel to expose the connector.
3. Replacement and Adjustment
72
To Next Page
Loading...
