PCDU
Photoconductor Cleaning/Development Unit
1. Open the front door.
2. Lower the by-pass tray, open the duplex unit, and open the transfer unit right cover.
3. Release the PCDU lock [A].
4. Hold the PCDU by the handle [B] and pull out slowly.
5. Remove the screws [C] ( x 3).
6. Pull the PCU horizontally then up [D] to separate it from the development unit [E].
7. Cover the drum with a clean sheet of paper to protect it from exposure to light.
- Reinstallation -
3. Replacement and Adjustment
82
To Next Page
Loading...
