Reviewing the Module Statuses
With the machine in the firmware update mode, follow this procedure to review the status of the firmware
modules.
Web Support
1. Push [Menu] to display the name of the first module.
ROM : G1475933
NEW: G1475933
• "ROM" is the name of the module in the machine.
• "NEW" is the name of the module on the SD card.
2. Push [Menu] again to display the version numbers of the modules.
ROM : 0.09
NEW : 0.19
• "ROM" is the version number of the module in the machine.
• "NEW" is the version number of the module on the SD card.
• If the "NEW" version number is higher than the "ROM" version number, the module must beup-
dated.
3. Push [Menu] to return to the previous level.
Web Support
4. Push to display the name of the next module, then push the [Menu] key again to review
the module name and version number.
5. Repeat this procedure to review the version numbers of the modules: Web Support, Network
Support, Onboard Sys, Onboard Prn, Engine, and NeworkDocBox.
How to Update a Module
Follow this procedure to update a module.
• Only one module can be updated at a time. The machine power must be turned off and on after each
module is updated.
Updating the Firmware
279
To Next Page
Loading...
