Ricoh A-P4 - Page 281

1. Set the machine in the firmware update mode. (See "Setting the Machine in the Firmware
Update Mode" above.)
Web Support
2. Push  or  to select the module that you want to update (Web Support, Network Support,
Onboard Sys, Onboard Prn, Engine, or NetworkDocBox).
Engine
3. Push [#Enter]. An asterisk appears below the name of the module, to indicate that it is
selected for update.
Engine
*
• Pushing [#Enter] toggles the asterisk on and off.
• Select only one module for the update. If you try to select another module, you will see the
message "Cannot Select". This means another module has already been selected for update.
• The firmware modules must be updated one at a time.
4. After selecting one module for updating, push  to display "Update Data".
Update Data
5. Push [#Enter] to start the update of the selected module.
Update Data
_ _ _ _ _ _ _ _ _ _ _ _
Asterisks replace the underscores in the progress line as the data updates.
Update Data
* * * _ _ _ _ _ _ _ _ _
When the update is completed, you will see:
Updated
Power Off On
5. Service Tables
280
5