1. Turn off the main switch.
2. Remove the SD card cover [A].
3. Plug the SD card [B] into SD card slot C3..
4. Turn on the main switch.
5. To enter the SP mode, press together (5 seconds), release, then press [#Enter].
6. Select SP5824.
SP5825
NVRAMDownload
7. Push [#Enter].
8. When the message prompts you to execute, push [#Enter].
<NVRAMDownload>
Processing
<NVRAMDownload>
result = OK
9. Remove the SD card.
10. Switch the machine off and on.
• If the SD card is not installed properly, a message will tell you that downloading cannot proceed.
Boards
139
To Next Page
Loading...
