003 Ctr (Bypass) [120°C ~ 220°C / 190°C / 1°C step]
004 Ends (By-pass) [120°C ~ 220°C / 190°C / 1°C step]
005 Ctr (Reload)
Adjusts the temperature for re-heating the center of the hot roller:
Reload Temp. = Fusing. Temp – SP Value
[0°C ~ 60°C / 30°C / 1°C step]
When the fusing temperature exceeds this setting, the machine can
operate.
Do not set a reload temperature (Spec. Temp – SP Value) higher
than the SP1105-02 setting.
006 Ends (Reload)
Adjusts the temperature for re-heating the ends of the hot roller:
Reload Temp. = Fusing. Temp – SP Value
[0°C ~ 60°C / 30°C / 1°C step]
When the fusing temperature exceeds this setting, the machine can
operate.
Do not set a reload temperature (Spec. Temp – SP Value) higher
than the SP1105-02 setting.
007 Ctr (Bypass) T
Adjusts the temperature of the center of the hot roller for feeding
thick paper with the by-pass tray.
[120°C ~ 220°C / 200°C / 1°C step]
008 End (Bypass) T
Adjusts the temperature of the ends of the hot roller for feeding thick
paper with the by-pass tray.
[120°C ~ 220°C / 200°C / 1°C step]
009 Ctr (Thick)
Adjusts the temperature for re-heating the center of the hot roller
for feeding thick paper:
Reload Temp. = Fusing. Temp – SP Value
[0°C ~ 60°C / 5°C / 1°C step]
When the fusing temperature exceeds this setting, the machine can
operate.
Do not set a reload temperature (Spec. Temp – SP Value) higher
than the SP1105-02 setting.
010 Ends (Thick)
Adjusts the temperature for re-heating the ends of the hot roller for
feeding thick paper:
Reload Temp. = Fusing. Temp – SP Value
Service Program Mode Tables
189
To Next Page
Loading...
