SP Mode SP Name
SP2201-01 Developer Bias – Image Dev. Bias Default: -540 V
SP2309-01 Paper Lower Width [a] Width limit. Default: 150 mm
SP2309-02 Paper Upper Width [b] Width limit. Default: 216 mm
SP2914-03 Process Ctrl Set – B gamma Adjust 10 V/step. Default 200 V
SP2914-04 Process Ctrl Set – B delta Adjust 10 V/step. Default 50 V
The way that these SP modes are used is shown below.
For example, with the default settings, if the paper width fed from the by-pass tray is 200 mm, the devel-
opment bias voltage will be –540 + 50 V.
Development
327
To Next Page
Loading...
