Troubleshooting
170
3
Changing the Paper Size
Preparation
The procedures for changing the
paper size are different depending
on the tray (paper tray 1, paper
tray 2 or the optional paper tray
units). Check that you are follow-
ing the appropriate procedure be-
fore you start.
Reference
⇒ p.57 “Copying from the Paper
Tray 2”
Important
❒ If you wish to change the paper
size set in the optional large capac-
ity tray (LCT), contact your service
representative.
❒ Be sure to select the paper size
with the user tools. Otherwise,
misfeeds might occur. Refer to the
System Settings manual.
Reference
For paper sizes, types, and weights
that can be set in each tray, and the
capacity of each tray ⇒ p.22 “Copy
Paper”.
Changing the Paper Size in
Tray 1-4/Paper Tray Unit
A
AA
A
Make sure that the paper tray is
not being used, and then fully
pull out the tray.
Note
❒ Make sure that there is no paper
left in the paper tray.
B
BB
B
While pressing the release lever,
adjust the back fence.
C
CC
C
Release the side lever.
To Next Page
Loading...
