Copying
56
2
To Stop Scanning Temporarily
When you are using the Sort, Stack, or
Staple function, the originals are
scanned into memory.
A
AA
A
Press the
{
{{
{
Clear/Stop
}
}}
}
key to stop
originals from being scanned into
memory.
To resume scanning
A
AA
A
Press the [
No
] key to resume
scanning.
Note
❒ Scanned images in memory
are not cleared.
To clear scanned images of the
originals
A
AA
A
Press the [
Yes
] key.
Scanning is stopped with the
images cleared.
When Memory Reaches 0%
Scanning will be stopped if the size of
scanned image data exceeds memory
capacity.
Note
❒ There is enough memory to store
approximate 1,000 originals of A4,
8
1
/
2
" × 11" size. The number of
originals that can be stored in
memory varies depending on the
memory setting and original type.
In addition, the number of origi-
nals that can be stored in memory
will be reduced when you use oth-
er functions.
Reference
Scanning will stop when memory
reaches 0% during sorted copying.
However, you can change this set-
ting so that all the scanned pages
are copied and delivered to the
tray. After which, the machine au-
tomatically continues scanning the
remaining originals. ⇒ "Memory
Full Auto Scan Restart" on p.204
“Input/Output”
A
AA
A
Press the
{
{{
{
Start
}
}}
}
key.
The scanned pages are delivered to
thetray.Then,theimagedatain
memory is cleared.
B
BB
B
Remove the copies and continue
copying by following the instruc-
tions on the display.
To Remove Paper from the
Staple Unit
If you cancel a stapling copy job in the
middle of the job, paper might be left
in the staple unit. In this case, remove
the paper from the staple unit.
A
AA
A
Press the
{
{{
{
Clear Modes
}
}}
}
keytocan-
cel the copy settings.
B
BB
B
Place the next original, and then
press the
{
{{
{
Start
}
}}
}
key.
Thepaperleftinthestapleunitis
automatically delivered, and then
the next job starts.
Note
❒ When paper is not delivered
and a message is displayed, fol-
low the instructions on the dis-
play to remove the paper.
To Next Page
Loading...
