Transmission Features
74
4
Checking the Transmission
Result
• Turn the Transmission Result Re-
port (Memory Transmission) on if
you want a report to be printed af-
ter every successful transmission.
⇒ Chapter 2, "Memory Transmis-
sion" in the Basic Features manual,
p.77 “Transmission Result Report
(Memory Transmission)”
If you leave the Transmission Re-
sult Report off, the report will not
be printed after every transmis-
sion. However, should a transmis-
sion fail, a Communication Failure
Report will be printed instead.
• If you turn the Transmission Re-
sult Report (Memory Transmis-
sion) off, the Error Report will be
printed when the communication
fails.⇒ p.78 “Communication Fail-
ure Report”
• You can also check the transmis-
sion result by examining the Jour-
nal.⇒ p.25 “Printing the Journal”
You can either print or scroll
through the Journal on the display.
⇒ p.27 “Checking the Transmis-
sion Result (TX File Status)”
Automatic Redial
If a fax message could not be transmit-
ted because the line was busy or an er-
ror occurred during transmission,
redialing is done 4 times at 5 minutes
intervals (these figures vary according
to which country you are in).
If redialing fails after four redials, the
machine cancels the transmission and
prints the Transmission Result Report
(Memory Transmission)⇒ p.77 or
Communication Failure Report.⇒
p.78
Batch Transmission
If you send a fax message by Memory
Transmission and there is another fax
message waiting in memory to be
sent to the same destination, that
message is sent along with your orig-
inal. Several fax messages can be sent
with a single call, thus eliminating the
need for several separate calls. This
helps save communication costs and
reduce transmission time.
Note
❒ You can choose whether Batch
Transmission is turned on. Set this
with the User Parameters. ⇒ p.141
“Changing the User Parame-
ters”(Switch14, Bit2)
❒ Fax messages for which the trans-
mission time has been set in ad-
vance are sent by batch
transmission when that time is
reached.
❒ If there are many messages wait-
ing in memory to be sent, they may
not be sent in the order of scan-
ning.
ECM (Error Correction Mode)
This feature automatically sends data
that was not transmitted successfully
using a system that complies with in-
ternational standards.
ECM requires that the destination
machine has the same feature.
Note
❒ You can choose whether ECM is
turned on. Set this with the Key
Operator Settings. ⇒ p.140 “ECM”
RusC2FaxADEN-F_V4_FM.book Page 74 Monday, August 20, 2001 10:52 AM
To Next Page
Loading...
