Sub Transmission Mode
69
4
-
--
-Label Insertion
When a destination is stored in Quick
Dials and "Label Insertion" is set to
"ON", the receiver's name will be print-
ed at the top of the page of message re-
ceived at the other end and will be
preceded by "To". You can also print a
sentence stored as a Standard Message.
Reference
⇒ p.116 “Programming Standard
messages”
⇒Chapter 2, "Quick Dials" in the
Basic Features manual
Note
❒ You can switch this feature on and
off in "General Setting/Adjust-
ment" (⇒ p.125).
Limitation
❒ When "Label Insertion Priority Set-
ting" is set to "Programmed Name"
and there is an image around the
area where the Label is to be print-
ed, that image is deleted. When
this setting is set to "OFF", Label
Insertion is not printed.
-
--
-Sender Stamp
When there is data, such as the user
name and department name, pro-
grammed into the user code, you can
have the machine print a sender
stamp on the right edge of your pa-
per. To print a sender stamp, press
[Change] and program a user name to
be printed. When you select [No
Stamp], a sender stamp is not printed.
Note
❒ Enter the user name in System Set-
tings.
-
--
-Reduced Image Transmission
When this feature is set to "ON", your
message is sent at a reduced size
(93%) with a blank margin on the left.
When this feature is set to "OFF", "Re-
duced Image Transmission" is can-
celed.
Limitation
❒ This feature is not available with
Immediate Transmission or a spec-
ified transmission of a stored doc-
ument.
❒ Image Rotation is not available
with this feature.
Note
❒ You can switch this feature on and
off in "General Setting/Adjust-
ment" (⇒ p.125)
-
--
-Auto Reduction
When this feature is set to "ON" and
the receiver's paper is smaller than
the original, the message is automati-
cally reduced to fit onto the paper
available at the other end. When this
feature is set to "OFF", "Auto Reduc-
tion" is canceled.
RusC2FaxADEN-F_V4_FM.book Page 69 Monday, August 20, 2001 10:52 AM
To Next Page
Loading...
