Getting Started
16
1
Connecting the IEEE 1394 Interface Cable to the Machine
Important
❒ Before connecting an interface cable between the machine and a personal
computer, make sure that the machine is not operating, and then turn off the
main power switches of the machine and personal computer. For notes on
turning off the main power switch of the machine, see "Turning on and off the
Power" in the System Settings manual or "Turning off the Power" in the Copi-
er Reference.
❒ Be sure to use the designated interface cable. Using another cable may cause
radio interference.
❒ Do not loop the 1394 interface cable.
❒ The IEEE 1394 interface can be used only on a personal computer that runs
under the Windows 2000 operating system.
❒ With Windows 2000, the 1394 Interface Unit can only be used with Service
Pack 1 or later. If the Service Pack is not installed, the connectable number of
devices in a 1394 bus is only one, and the client cannot access the 1394 Inter-
face Unit without using an account that has Administrators permission.
❒ Outputting is not possible with Windows 95, 98, or Me. If the “plug and
play”function starts, click [cancel].
❒ The Ethernet Board cannot be installed on the machine together with the IEEE
1394 Board.
A
AA
A
Attach the IEEE 1394 Interface cable to the ports on the board.
Both ports are available.
ZFFH300E
RussianC2-EN-PrREF1_V4_FM.book Page 16 Wednesday, August 8, 2001 3:52 PM
To Next Page
Loading...
