Sub Transmission Mode
67
4
Note
❒ To print both sides, press [Print 2
Sided].
G
GG
G
Press the {
{{
{Start}
}}
} key.
Note
❒ When only the first page is
printed, the file name is printed
at the top of the paper.
❒ To cancel printing, press [Can-
cel].
H
HH
H
Press [Cancel].
Note
❒ You can also fax a specified
Stored Document.⇒ p.62
“Sending Stored Documents”
The Sub Transmission Mode menu
is shown.
Stamp
The optional Document Feeder (ADF) is
required.
When sending a fax message using
the Document Feeder (ADF), the ma-
chine can stamp a circle mark at the
bottom of the original. When sending
a 2– sided document, the document is
marked at the bottom of the front
page and top of the rear page. This
stamp indicates that the original has
been successfully stored in memory
for Memory Transmission, or that it
has been successfully sent for Imme-
diate Transmission.
Limitation
❒ Stamp only works when scanning
from the Document Feeder (ADF).
❒ You cannot turn the Stamp feature
on or off while a document is being
scanned.
❒ Do not open the document feeder
(ADF) while scanning a document.
A document jam could occur.
Note
❒ When the stamp starts getting
lighter, replace the cartridge. ⇒
p.185 “Replacing the Stamp Car-
tridge”
❒ If a page was not stamped even
though the Stamp feature is turned
on, you need to resend that page.
❒ You can choose whether Stamp is
turned on or off. Select this in
"General Settings/Adjustment"(⇒
p.125). If you set it on, Stamp can
easily be turned off for any single
transmission by pressing [Stamp].
A
AA
A
Place your original ,and then se-
lect any scan settings you require.
B
BB
B
Press [Sub TX Mode].
The Sub Transmission menu is
shown.
RusC2FaxADEN-F_V4_FM.book Page 67 Monday, August 20, 2001 10:52 AM
To Next Page
Loading...
