Using the Control Panel
56
5
Memory Usage You can select the volume of memory to be used in the “Font Pri-
ority” or “Frame Priority”, according to the paper size or resolu-
tion.
• Font Priority
This setting uses memory for registering fonts.
• Frame Priority
This setting uses frame memory for high speed printing.
Note
❒ Default: Frame Priority
Edge Smoothing You can set whether or not to enable “Edge Smoothing”.
• On
• Off
Note
❒ Default: On
❒ If “Toner Saving” is “On”, “Edge Smoothing” is ignored even
if it is “On”.
Resolution You can set the print resolution in dots per inch.
❖
❖❖
❖ PCL 5e
300 dpi, 600 dpi
❖
❖❖
❖ PCL 6
600 dpi
❖
❖❖
❖ PS
300 dpi, 600 dpi
Note
❒ Default: 600 dpi
❒ The PCL 6 can only be set to 600 dpi.
Toner Saving You can select whether or not to enable “Toner Saving”.
• On
• Off
Note
❒ Default: Off
❒ If “Toner Saving” is “On”, “Edge Smoothing” is ignored even
if it is “On”.
Menu Description
To Next Page
Loading...
