Reading the Display
13
1
F
Appears when a destination is entered. Press [Clear] to erase characters or
numbers one by one.
G
Switches the transmission mode between memory transmission and immedi-
ate transmission.
H
Displays Quick Operation Keys set for often used functions.
[TX status display] and [Dest. Management] are preset.
I
Displays various functions for transmitting.
J
Displays the Quick Dial table of programmed destinations.
-
--
-User Code Management
The machine can be set up so that no one can use it without entering a user code.
This prevents unauthorized people from sending fax messages and helps track
the activity of each user.
Note
❒ You can specify a user code with "System Settings".
❒ Even when user code management is set to on, you can still receive and print
fax messages as usual.
❒ When you specify a user name, all reports are printed with the user name in
the user code area.
A
When the following message appears on the display, user code management
is set to on.
B
Enter a user code of up to 8 digits with the number keys.
C
Press [#].
Note
❒ If an unprogrammed user code is entered, the display returns to step A.
To Next Page
Loading...
