Ricoh Aficio 1022 - Page 650

Setup
68
3
Note
❒ If the destination is pro-
grammed with the number
keys, press the {
{{
{Clear/Stop}
}}
}
key or [Clear] and enter the
fax number of the destina-
tion.
❒ If the destination is pro-
grammed with the Quick
Dial table, press the
{
{{
{Clear/Stop}
}}
} key or [Clear] to
cancel programming, and
then program with the desti-
nation key again. You can
cancel programming also by
pressing the destination key.
❒ Press [Adv. Features] to edit F
code, sub-address or UUI. ⇒
Chapter 4, "Advanced Fea-
tures" in the Advanced Fea-
tures manual
❒ You can select a line type for
each destination when the
ISDN Unit (option) or Extra
G3 Interface Unit (option) is
installed. Press [Select Line] to
select a line type. ⇒ Chapter
4, "Changing the Line Type"
in the Advanced Features
manual
❒ To edit another destination,
press [Dest.List] and proceed
from step D.
Adding destinations
A
AA
A Press [Add].
B
BB
B Add the destination using the
number keys or a destination
key.
Note
❒ To add another destination,
press [Dest.List] and proceed
from step D.
❒ You also can cancel program-
ming also by pressing the
destination key of the desti-
nation to be added.
❒ Press [Adv. Features] to pro-
gram F code, sub-address or
UUI. ⇒ Chapter 4, "Ad-
vanced Features" in the Ad-
vanced Features manual
❒ You can select a line type for
each destination when the
ISDN Unit (option) or Extra G3
Interface Unit (option) is in-
stalled. Press [
Select Line ] to se-
lect a line type. ⇒ Chapter 4,
"Changing the Line Type" in
the Advanced Features manual
E
EE
E
Press [OK].
Note
❒ If you press [Cancel], the group
is not changed. The display ap-
pears as in step
C
.