Sending at a Specific Time (Send Later)
5
1
Note
❒ If the current time shown on the
display is not correct, change it.
⇒ "Timer Setting" in the System
Reference manual
❒ When entering numbers small-
er than 10, add a leading zero.
❒ If you make a mistake, press the
{
{{
{Clear/Stop}
}}
} key or [Clear] and
try again.
❒ To cancel your procedure, press
[Cancel] and the display will re-
turn to the Transmission Mode
menu.
E
EE
E
Press [OK].
The Transmission Mode menu is
shown on the display. The Send
Later key is highlighted, and the
specified time is shown above.
F
FF
F
Press [OK].
The initial display is shown.
Note
❒ To check settings, press [Trans-
mission Mode] .
G
GG
G
Dial and press the {
{{
{Start}
}}
} key.
Note
❒ You can cancel a message trans-
mission set up for Send Later. ⇒
p.17 “Canceling a Transmis-
sion”
RusC2FaxADEN-F_V4_FM.book Page 5 Monday, August 20, 2001 10:52 AM
To Next Page
Loading...
