Ricoh B089 - Page 251

SERVICE PROGRAM MODE
SM 4-35 B089/B093
Service
Tables
F Paper Size Selection 5129*
Selects the “F” paper size.
[0 ~ 2 / 0 / 1 step]
0: 8" x 13"
1: 8.5" x 13"
2: 8.25" x 13"
Paper Size Type Selection 5131*
Selects the paper size (type) for both originals and copy paper.
[0~2 / DIP SW setting / 1 step]
0: Japan
1: North America
2: Europe
After changing the setting, turn the copier off and on. If the paper size of the
archive files stored on the HDD is different, abnormal copies could result. Ask the
customer to restore the archive files.
By-Pass Length Setting 5150*
Determines whether long paper can be fed from the by-pass tray.
[0 = Off, 1 = On]
Normally the paper length from the by-pass tray is limited to 600 mm, but this can
be extended with this SP to 1260 mm.
Note that, with either setting, the image quality can only be guaranteed for 432
mm.
Application Switch Method 0: HW, 1: SW5162*
Determines whether the application screen is switched with a hardware switch or
software switch.
0: Soft Key Set
1: Hard Key Set
5212* Page Numbering
5212 3 Duplex Printout Right/Left Position
Determines how horizontal printing is executed during duplex printing. Set the
upper right corner of the front side and the upper left corner of the back side so the
starting points for horizontal printing are the same on both sides DFU.
[–10~+10 / 0 / 1 mm step]
–10: Extreme right
+10: Extreme left
5212 4 Duplex Printout High/Low Position
Determines how vertical printing is executed during duplex printing. Set the upper
right corner of the front side and the upper left corner of the back side so the
starting points for vertical printing are the same on both sides. DFU
[–10~+10 / 0 / 1 mm step]
–10: Extreme top
+10: Extreme bottom