CORRECTING THE IMAGES
B089/B093 6-48 SM
Procedure A :
Fig. 1: Rear, left upper side of machine Fig. 2: (similar view)
1. Remove the rear and left covers, then the left scanner cover.
2. Check to see if there is a gap ([A]) between the scanner unit holder and frame.
3. If there is no gap, this means that the left front section of the scanner unit is
positioned lower than the standard.
4. Loosen all 7 screws (Fig. 2) and lift up the left front portion of unit until there is
a 1 to
2 mm gap between the two.
5. Tighten the screws.
6. Place a washer (P/N 07080050, 1mm thick) in between the two to occupy the
gap [A].
Fix the washer in place using an instant-acting adhesive.
Note: This washer will also act to absorb minor amounts of shock.
7. Check whether the parallelogram image still appears.
To Next Page
Loading...
