Ricoh J-P2 - Page 246

PRINTER ENGINE SERVICE MODE 17 January, 2003
5-58
5
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
[ColorGapAdj2] Color Gap Adjustment 2
2 ManAdjust A
3 ManAdjust B
4 ManAdjust C
5 ManAdjust D
6 ManAdjust E
7 ManAdjust F
8 ManAdjust G
9 ManAdjust H
10 ManAdjust I
11 ManAdjust J
12 ManAdjust K
13 ManAdjust L
Adjusts the values of Manual Adjustments A
through L.
[ -70 to 70 / 0
/ 0.5/step ] DFU
14 FusVelAdjust Optimizes the line speed of the fusing unit by
adjusting the speed of development motor-K. DFU
15 FusVelChange Changes the line speed of the fusing unit for
outputting the Fuser Adjust Sheet.
[ 0 to 7 / 0
/ 1/step ] DFU
995
16 ResultSend
Stores the line speed in the NVRAM. DFU
[Test Pattern]
1 IntTray Selects the tray for making a test print.
[ 0 to 4 / 1
/ 1/step ]
0: By-pass Table 1: Tray 1
2: Tray 2 3: Tray 3
4: Tray 4
NOTE: The machine makes a test pattern on the
paper size loaded in the selected paper
tray.
997
2 Pattern Selects a test pattern.
[ 0 to 23 / 0
/ 1/step ]
0: None
1: 1-dot sub-scan line
2: 2-dot sub-scan line
3: 1-dot main-scan line
4: 2-dot main-scan line
5: 1-dot grid pattern (fine)
6: 2-dot grid pattern (fine)
7. 1-dot grid pattern (rough)
8. 2-dot grid pattern (rough)
9. 1-dot slant grid pattern
10. 2-dot slant grid pattern
11. 1-dot pattern
12. 2-dot pattern
13. 4-dot pattern
14. 1-dot trimming pattern
15. 2-dot trimming pattern
16. Cross stitch: sub-scan
17. Cross stitch: main-scan
18. Belt pattern
19. Belt pattern (vertical)
20. Checkered Flag
21. Grey scale (vertical)
22. Grey scale (Horizontal)
23. Solid