Ricoh SP C260SFNw - Page 347

Message Causes Solutions
Cannot Copy This
Setting
Combine.: 2 page on
1 / 4 page on 1
Combined copying could not be
performed because the tray
does not contain the valid size
paper, which are A4, Letter, or
Legal size.
• Set the machine to print copies using
the A4, Letter, or Legal size paper in
the [Select Paper] setting. See
page 223 "Copier Features Settings".
• Specify the A4, Letter, or Legal size
paper for the tray selected for printing
copies. See page 252 "Paper
Settings".
Cannot copy.
Set original to ADF.
Combined copying could not be
performed because the originals
were not placed in the ADF.
• Use the ADF, even when copying a
single sheet.
• If you need to use the exposure glass,
select [Off] or [Manual 2Sd Scan
Mode] in [Duplex/Combine] under
[Copier Features], and then try again.
See page 223 "Copier Features
Settings".
Check Paper Size The paper size set for the
document differs from the size of
the paper in the indicated tray.
Press [FormFeed] to begin printing, or
press [JobReset] to cancel the job.
Check Paper Type The paper type set for the
document differs from the type
of the paper in the indicated
tray.
Press [FormFeed] to begin printing, or
press [JobReset] to cancel the job.
Connection Failed The line could not be connected
correctly.
• Confirm that the telephone line is
properly connected to the machine.
• Disconnect the telephone line from
the machine, and connect a standard
telephone in its place. Confirm that
you can make calls using the
telephone. If you cannot make calls
this way, contact your telephone
company.
Cover open A cover is open. Close the cover completely.
Density Sensor
Require Cleaning
The machine failed to adjust
color registration.
Clean the toner density sensor. See
page 330 "Cleaning the Toner Density
Sensor".
Error and Status Messages on the Screen
345