Technical Bulletin PAGE: 5/9
Model: Taurus-C1/P1 (D074/D075/M044) Date: 15-Feb-12 No.: RD074045
Setting up Tera Term (Log Monitor)
1. Activate Tera Term.
Activate two Tera Term windows on your PC for Master and for Slave.
2. Open “Terminal setup” by selecting [Setup] > [Terminal], and specify the settings as
shown below. Do this procedure for the two Tera Terms.
3. Open “Serial port setup” by selecting [setup] > [Serial port], and specify the settings as
below. Do this procedure for the two Tera Terms. Check the “Port” for each Tera Term.
Active the two Tera Terms on your PC.Active the two Tera Terms on your PC.
To Next Page
Loading...
