Technical Bulletin PAGE: 4/9
Model: Taurus-C1/P1 (D074/D075/M044) Date: 15-Feb-12 No.: RD074045
5. Connect the debug cables to each of the connectors on the BCU board.
6. Connect the other end of the debug cables to the serial port or to the USB port on the
PC using a USB-serial conversion cable.
Connect the two cables to your PC.Connect the two cables to your PC.
Cable for the
Master connecto
Cable for the
Slave connecto
hand.
Cable for the
Master connector
Cable for the
Slave connector
NOTE: The two cables for Master and
Slave are different in this photo but there
are no differences in their functions.
Please use a cable in hand.
To Next Page
Loading...
