Technical Bulletin PAGE: 3/16
Model: Taurus-C1/P1 (D074/D075/M044) Date: 10-Apr-12 No.: RD074060
1-2. Achieving the recommended skew range
The procedure for achieving the recommended skew range is in the Field Service Manual
(2. Installation > Main Machine > Checking the Print Quality > Image Skew Check).
The following is a supplementary explanation.
1. Set A3 or DLT plain paper (63.1-80.0 gsm) in Tray 2 and apply this to the paper tray
setting.
2. Print 5 copies of the test pattern Trimming Area (SP2109-003-14) in b/w and simplex.
3. Measure the two locations (a) and (b) on all 5 copies.
4. Calculate the skew amount “(a) – (b)” on all 5 copies. If the values are within the
recommended range +/- 0.4mm, go to step 7. (Specification; (a) – (b) = +/- 1.0mm)
5. Remove the right drawer cover, and adjust the adjustor plate.
NOTE
One notch on the scale is equivalent to a skew adjustment of
approximately 0.3mm. Setting the plate to a value smaller
than –2 could cause Jam97. See section 1-3. ‘Possible
problems involving skew correction’ for instructions on
preventing Jam97.
To Next Page
Loading...
