Technical Bulletin PAGE: 3/6
Model: Taurus C1/P1 (D074/D075/M044)
Note 1: Cleaning the bottom side of the dev unit
1. Pull out the affected dev unit, and then clean the bottom side with a piece of cloth and alcohol.
Note 2: Cleaning the doctor gap
1. Remove the casing. (Screw x3)
2. Tilt the unit 90 degrees so that the left side (viewed from the front) faces the bottom, then
rotate the dev roller in the direction indicated with the arrow (counterclockwise viewed from
rear) until the loose developer on the roller surface is cleaned off.
IMPORTANT
DO NOT rotate the dev roller in the opposite direction because this will cause the Mylar to get
sucked into the roller.
To Next Page
Loading...
