Ricoh Taurus-C1a - Page 438

Technical Bulletin PAGE: 5/6
Model: Taurus C1/P1 (D074/D075/M044)
Date: 27-Jan-13
No.: RD074112
NOTE
Both ends of the tool can be used. Locate the hole in the tool. Slide the tool from Right  Left
when inserting the end having the hole. Slide the tool from Left  Right when using the other end.
IMPORTANT
Make sure to note the following points to prevent scratches on the surface of the development
roller.
 DO NOT push and pull the tool.
 DO NOT press the tool against the dev roller with your thumb.
 DO NOT touch the roller with your fingers.
Use this end to slide Right  Left.
Use this end to slide Left  Right.