Technical Bulletin PAGE: 10/58
Model: Taurus-C1 / P1 Date: 21-Oct-11 No.: RD074026
<Main Machine \ Installation: Power Off \ Attention Light >
Screws for fixing the Attention Light were changed.
Before the Revision After the Revision
1. The attention light is installed on the top rear edge
[A] with accessory screws (
x3 M4x8).
1. The attention light is installed on the top rear edge
[A] with accessory screws ( x3 M4x6).
• The three screws must be removed from their
holes (these screws are not accessories).
<Main Machine \ Installation: Power Off \ Install Operation Panel: Standard
Installation >
Instructions were revised accordingly with the change in screw type.
Before the Revision After the Revision
13. Fasten the back of the operation panel [A] to the
mounting bracket [B] (
x4).
• You will need a short screwdriver to attach the
screw at
.
13. Fasten the back of the operation panel [A] to the
mounting bracket [B] (
x4 M4x6). You will
need a short screwdriver to attach the screw at
.
• You must use the M4x6 screws to fasten the
operation panel at this step. If you use the
longer screws (M4x8) they could touch and
damage the operation panel board.
To Next Page
Loading...
