Technical Bulletin PAGE: 11/58
Model: Taurus-C1 / P1 Date: 21-Oct-11 No.: RD074026
<Main Machine \ Installation: Power Off \ Operation Panel: Easy Access Installation
>
Instructions were revised accordingly with the change in screw type.
Before the Revision After the Revision
20. Check the hooks at and to make sure that
the operation panel [A] is hung correctly on the
mounting plate [B].
21. Fasten the operation panel and mounting plate
together (
x4). (You will need a short
screwdriver to attach screw [C]).
6. Check the hooks at and to make sure that the
operation panel [A] is hung correctly on the
mounting plate [B].
7. Fasten the operation panel and mounting plate
together (
x4 M4x6). (You will need a short
screwdriver to attach screw [C]).
• You must use the M4x6 screws to fasten the
operation panel at this step. If you use the
longer screws (M4x8) they could touch and
damage the operation panel board.
<Main Machine \ Installation: Power Off \ Attach Decals >
Description of decal attachment was newly added.
1. Attach the decals at the locations shown above.
[A] Precautions for Printing decal
[B] Original Set Precautions decal
[C] Cleaning, Prohibited Copying decals
To Next Page
Loading...
