Roche Cedex Bio - Page 553

Roche Diagnostics
Operator’s Manual · Version 3.4 G-19
Cedex Bio analyzer Index
reagent disks
–cleaning, D–14
– ID, A–58
–loading, B–23
–overview, A–57
– preparing, B–126
– realigning, E–50
– removing, B–95
– storage container, A–58
reagent handling, overview, A–26
reagent lots
– viewing, B–107
reagent mixing
– screen, A–118
reagent sets, A–26
– checking status, B–25
– deleting from inventory, B–130
reagent status, screen, A–96
reagents
– barcodes, A–60
– bottles, A–53
–cooling, A–58
– exchanging, B–27
– handling, A–56
– introduction to handling, A–26
–loading, B–28
– preparing, B–24, B–27
– removing, B–27
– replacing, B–27
–safety, A–7
– sets, A–26
reference ranges, ratios, B–166
refilling
– printer paper, B–132
– water container, B–18, B–94
removing, B–56
– reagent disk, B–95
– reagents, B–27
–sample tubes, B–56
repeating, tests, B–61
Replace ISE pump tubing, maintenance action, F–58
Replace ISE unit tubing, maintenance action, F–61
Replace photometer lamp, maintenance action, D–22
Replace water inlet filter, maintenance action, D–18
replacing
– cleaner bottle, B–20
– cuvettes, B–31, B–93
– electrodes, F–36
– ISE bottles, F–24, F–33
– printer paper, B–132
– probe, B–135
– reagents, B–27
– water container, B–18, B–94
replicate mean, C–26
rerunning, tests, B–62
restarting the system, A–125
restoring database, B–123
result conversion, B–166
result handling
– definitions, B–179
– overview, A–34
result list, screen, A–102
results
– calculation checks, C–26
– calculation replicate mean, C–26
–calibration, B–71
– calibration modes, C–23
– checking for not accepted sample results, B–88
– checking for transmission, B–89
– cleaning up at end of shift, B–92
– corrections, C–25
– deleting of calibration, B–103
– deleting of QC, B–104
– deleting of samples, B–102
– exporting, B–91, B–114
– flags, E–23
– handling, A–34
–introduction to handling, A–34
– laboratory conversion, C–28
– list, A–102
– printing of samples, B–64
– quantitative calculation, C–23
– samples, B–57
– samples, if sample on board, B–58
– samples, if sample removed, B–59
– validating for QC, B–78
– validating of samples, B–57
revision history, 2
rinse station, A–47
rotor
– cleaning, D–10
– overview, A–56