Channel Menu R&S
®
ZVA/ZVB/ZVT
1145.1084.12 4.180 E-6
• Config Ext. Power Meters... opens the System Configuration – External Power Meters dialog for
adding and configuring external power meters.
• Take Cal Sweep in the three numbered panels start the calibration sweeps for the RF source,
IF receiver, and the LO source, respectively. The calibration sweep are performed at the test
settings defined in the Source Power Cal and Receiver Power Cal menus. A popup box shows
the progress of the calibration.
Remote control:
SOURce<Ch>:POWer<Pt>:CORRection:PMETer:ID
SOURce<Ch>:POWer<Pt>:CORRection:MIXer:RF[:ACQuire]
[SENSe<Ch>:]CORRection:POWer<port_no>:MIXer:IF:ACQuire
SOURce<Ch>:POWer<Pt>:CORRection:MIXer:LO[:ACQuire]
To Next Page
Loading...
