1145.1084.02 RE.5 E-6
What's New in this Revision
This manual describes version V1.80 of the ZVA/ZVB/ZVT firmware. Compared to the previous version
V1.78, the new firmware provides numerous extensions and improvements. The major new features
and bug fixes are listed below.
To check your ZVA/ZVB/ZVT firmware version, click Help – About Nwa...
New Features in Firmware V1.80 (Compared to V1.78)
New measurement mode: Frequency Conversion (option R&S ZVA-K4, including Harmonic
Distortion measurements and Mixer Mode)
New calibration type: Power calibration
Support for external test devices: External generators and power meters can be controlled
via USB, LAN, GPIB bus, or other interface types
Adaptive Gain Control (AGC) of the receiver
Automatic Level Control (ALC) of the source
Low Phase Noise mode
Extended bandfilter search mode: Bandpass Search Ref to Marker
Improved access to the time domain and frequency domain stimulus values in the Transform –
Time Domain Stimulus Axis menu.
Frequency Step Size is a setting parameter for frequency sweeps
Marker values can be exported to an ASCII file.
New remote control command [SENSe<Ch>:]CORRection:COLLect:METHod? returns a list
of all calibration types for channel <Ch>.
New remote control commands [SENSe<Ch>:]CORRection:CONNection and
[SENSe<Ch>:]CORRection:CONNection:DELete configure and delete user-defined
connector types.
New remote control command [SENSe<Ch>:]CORRection:CKIT:<std_type> defines the
parameters of arbitrary connector types.
New remote control commands SYSTem:SOUNd:ALARm[:STATe] and
SYSTem:SOUNd:ALARm[:STATe] switch alarm and status sounds on or off.
Fixed Issues
Trace mathematics can distinguish between voltages and dimensionless quantities (Result is
Wave Quantity).
Zero Delay at Marker can now be used for all ports, the arithmetic problems have been solved.
To Next Page
Loading...
