1145.1084.02 RE.6 E-6
Improvements in Firmware V1.78 (Compared to V1.77)
Performance improvements for very large numbers of simultaneous channels/traces
New Features in Firmware V1.77 (Compared to V1.75)
New calibration standard: Sliding match.
The 7-term calibration types TOM, TRM, TRL, and TNA can be used for an arbitrary number of
ports.
Two new calibration types: TSM Enhanced and TOM Enhanced.
Sweep segment-specific IF gain for received waves including Automatic Gain Control (AGC).
New Features in Firmware V1.75 (Compared to V1.70)
The channel bits are switched over without intermediate reset when the measuring channel is
changed. The bits always correspond to the current measuring channel.
During a calibration sweep the channel bits of the calibrated channel are activated (instead of
the reset values).
When a new channel is created, the channel bits automatically take on the values of the
previous channel.
Calibration via remote control works for all channels without restriction.
Touchstone files for more than 4 (and up to 8) ports are supported.
A measurement wizard for up to 4 ports is available for ZVT analyzers.
Automatic calibration works correctly after a balanced port configuration is configured in the
measurement wizard.
New Features in Firmware V1.70 (Compared to V1.62)
New measurement: Virtual Transform (Embedding/De-Embedding)
Sweep range can be defined by Sweep Step Size
Alternative conversion of wave quantities in trace mathematics
Data to Memory function can be applied to all data traces at once
New softkey Recall Last Cal Set
Export of formatted trace data
Renormalization of reference impedances for the test ports with complex values
To Next Page
Loading...
