Rohde & Schwarz R&S ZVA 8 - Page 521

R&S
®
ZVA/ZVB/ZVT CALCulate
1145.1084.12 6.59 E-6
CALCulate<Ch>:FSIMulator:BALun:DMCircuit:BPORt2:PARameters:C
<Capacitance>
Defines the serial capacitance for the matching network.
<Ch>
Channel number.
<Capacitance>
Serial capacitance for logical port no. 2.
Range [def. unit] –1 mF to 1 mF [F (farad)]. The increment (parameters UP or
DOWN) is 1E-015 F.
*RST value 1E-009 F
SCPI, Command
Types
Device-specific, command or query.
Example:
*RST; CALC:FSIM:BAL:DEV SBAL
Select the matching network type single-ended/balanced (the
default setting may change in future firmware versions).
CALC:FSIM:STAT ON
Activate the matching network.
CALC:FSIM:BAL:DMC:BPOR2:PAR:C 2 NF; :L 2 NH
Set the serial capacitance to 2 nF and the parallel inductance to 2
nH.
:CALC:FSIM:BAL:DZC:BPOR2:ZCOM 50; ZDIF 150
Set the common mode impedance to 50 Ω, the differential mode
impedance to 150 Ω.
CALCulate<Ch>:FSIMulator:BALun:DMCircuit:BPORt2:PARameters:L
<Inductance>
Defines the parallel inductance for the matching network.
<Ch>
Channel number.
<Inductance>
Parallel inductance for logical port no. 2. The increment (parameters
UP or DOWN) is 1E-015 H.
Range [def.
unit]
–1 mH to 1 mH [H (henry)]
*RST value 1E-009 H
SCPI,
Command
Types
Device-specific, command or query.
Example:
See CALCulate<Ch>:FSIMulator:BALun:DMCircuit:BPORt1:PARameters:C