Rohde & Schwarz R&S ZVA 8 - Page 762

TRIGger<Ch>... R&S
®
ZVA/ZVB/ZVT
1145.1084.12 6.300 E-6
TRACe[:DATA]:STIMulus[:ALL]? CH1DATA | CH2DATA | CH3DATA | CH4DATA |
CH1MEM | CH2MEM | CH3MEM | CH4MEM | MDATA1 | MDATA2 | MDATA3 |
MDATA4 | MDATA5 | MDATA6 | MDATA7 | MDATA8
Returns the stimulus values of the active data trace or memory trace (see trace names).
To read the stimulus values of an arbitrary data or memory trace, use
CALCulate<Ch/Tr>:DATA:STIMulus?
<Response>
Response data of the selected trace, see list of trace names.
Range [def. unit] The data is transferred in the data format defined via
FORMat[:DATA]. The numeric values are expressed in the default
unit of the stimulus variable. [Hz, dBm or s, depending on the sweep
type]
*RST value –
SCPI,
Command
Types
Device-specific, query only
Example:
SWE:POIN 20
Create a trace with 20 sweep points, making the created trace the
active trace of channel 1 (omitted optional mnemonic SENSe1).
TRAC:STIM? CH1DATA
Query the 20 stimulus values of the created trace. In the default
format setting, the data is returned as a comma-separated list of 10-
digit ASCII values.
TRIGger<Ch>...
This subsystem is used to synchronize the analyzer's actions (in particular, the start of a measurement
sequence) with events.
TRIGger<Ch>[:SEQuence]:HOLDoff <numeric_value>
Sets a delay time between the trigger event and the start of the measurement (Trigger Delay).
<Ch>
Channel number. If unspecified the numeric suffix is set to 1.
<numeric_value>
Delay time.
Range [def. unit] 0 s to 13680 s [s]. UP and DOWN increment/decrement the
trigger delay in 10 ms steps.
*RST value 0 s
SCPI, Command
Types
Confirmed, command or query
Example:
TRIG:SOUR TIM
Activate internal timer as trigger source.
TRIG:HOLD UP
Set a delay time of 10 ms.