Rohde & Schwarz Scope Rider RTH1004 - Page 124

Spectrum Analysis
R&S
®
Scope Rider RTH
124User Manual 1326.1578.02 ─ 12
You can configure which peaks the instrument will find within the spectrum results.
Peaks are indicated by markers in the power vs frequency display. The frequency and
power level measured at the peak is also indicated in the diagram.
Overlapping markers
If two detected peaks are very close to each other and the markers in the display over-
lap, the marker with the lower amplitude is indicated in a darker color and put slightly in
the background, while the one with the higher amplitude is displayed normally. Using
the remote commands, both values can be retrieved.
Remote commands for results:
SPECtrum:MARKer:RESult<m>:FREQuency[:VALue]? on page 364
SPECtrum:MARKer:RESult<m>:FREQuency:DELTa? on page 364
SPECtrum:MARKer:RESult<m>:LEVel[:VALue]? on page 364
SPECtrum:MARKer:RESult<m>:LEVel:DELTa? on page 365
SPECtrum:MARKer:RMARker:FREQuency? on page 365
SPECtrum:MARKer:RMARker:VALue? on page 365
State............................................................................................................................125
Number of Markers..................................................................................................... 125
Threshold.................................................................................................................... 125
Peak excursion............................................................................................................125
Distance...................................................................................................................... 126
Trace Source...............................................................................................................126
Marker Value............................................................................................................... 126
Spectrum Mode (Option R&S
RTH-K18)