Multimeter Measurements
R&S
®
Scope Rider RTH
153User Manual 1326.1578.02 ─ 12
Figure 7-6: Voltmeter settings
Select Meter
Selects one of the 4 voltmeters and displays its settings in the menu.
Meter <n>
Switches the selected meter on or off.
Remote command:
METer<m>:SENSe:STATe on page 395
Measure Type
Sets the measurement type for the selected meter.
Note: The AC coupling is activated if the selected channel is only used for AC mea-
surements. If the selected channel is also used for DC or AC+DC measurement, the
AC coupling is deactivated and the AC value is calculated out of the AC+DC and DC
values. The precision of the results is reduced.
Menu icon Meter icon Description
AC voltage or current measurement
AC+DC voltage or current (RMS) measurement
DC voltage or current measurement
Note: An external shunt resistor or I/U converter is needed for current measurement.
Remote command:
METer<m>:SENSe:FUNCtion on page 401
Voltmeter (R&S
RTH1004)
To Next Page
Loading...
