Rohde & Schwarz Scope Rider RTH1004 - Page 152

Multimeter Measurements
R&S
®
Scope Rider RTH
152User Manual 1326.1578.02 ─ 12
b) Adjust the "Probe Setting" for all measured channels.
See also "Probe Setting" on page 42.
2. If the 4-voltmeter-view is shown, switch to the one-voltmeter-view.
See "Displaying voltmeters" on page 151.
3. Select the channel to be measured (no. 8 in Figure 7-4).
4. Select the measurement type (no. 10).
5. Activate the voltmeter (no. 13)
6. To adjust the measurement range, press the [Range] keys.
7. If you want to get relative result values:
a) Activate "Relative" (no. 12).
b) To set a user-defined reference value, open the "Meter" menu.
c) Activate "Reference", and enter the reference value in "Reference Manual".
8. To stop the meter measurement, press the [RUN STOP] key.
The status "Hold" is displayed on the upper left. Stopping the measurement does
not delete statistical values. The measurement continues when you press [RUN
STOP] again.
Alternatively, you can select the voltmeter and adjust the meter settings in the "Meter"
menu.
7.2.4 Voltmeter Settings
Access: "Meter" menu
Voltmeter (R&S RTH1004)