Multimeter Measurements
R&S
®
Scope Rider RTH
154User Manual 1326.1578.02 ─ 12
Input Signal
Selects the channel which is measured by the selected meter.
Remote command:
METer<m>:SENSe:SOURce on page 395
Relative
Activates or deactivates relative measurement. If you activate this function, the cur-
rently measured value is taken as reference value. Instead of the bargraph, the refer-
ence value and the measured value are displayed (see Figure 7-7). You can also set a
desired value as reference value, see "Reference/Reference Manual" on page 154.
Figure 7-7: Relative measurement
1 = Reference value
2 = Measured value relative to reference value
Remote command:
Chapter 15.8.3, "Relative Measurements", on page 399
Reference/Reference Manual
"Reference" activates or deactivates the manual reference value.
If active, enter the reference value in "Reference Manual".
Restart Test
Restarts the measurement and also restarts statistical calculation.
[RANGE] / [POS]
In meter mode, the vertical [RANGE] and [POS] keys adjust the measurement range of
the selected channel.
Remote command:
Chapter 15.8.2, "Measurement Configuration", on page 395
Voltmeter (R&S RTH1004)
To Next Page
Loading...
