Rohde & Schwarz Scope Rider RTH1004 - Page 263

Frequency Counter (R&S RTH-K33)
R&S
®
Scope Rider RTH
263User Manual 1326.1578.02 ─ 12
The diagram at the top of the "Counter" menu indicates how the data will be processed
using the current settings.
Select Counter............................................................................................................ 263
Counter 1 / 2 State...................................................................................................... 263
Input Signal................................................................................................................. 263
Reference....................................................................................................................264
Restart.........................................................................................................................264
Select Counter
Selects the counter to be configured.
Remote command:
Suffix for COUNter, see Chapter 15.9, "Counter Mode (R&S RTH-K33)", on page 406
Counter 1 / 2 State
Activates or deactivates the basic counter.
Remote command:
COUNter<m>:SENSe:STATe on page 412
Input Signal
Selects one of the channels as the input for the counter measurement.
Remote command:
COUNter<m>:SENSe:SOURce on page 412
Counter Settings