Rohde & Schwarz Scope Rider RTH1004 - Page 320

Remote Control Commands
R&S
®
Scope Rider RTH
320User Manual 1326.1578.02 ─ 12
LONGer | SHORter
Triggers on pulses shorter or longer than a runt width that is
defined by TRIGger:RUNT:WIDTh.
EQUal | NEQual
Triggers pulses with a width equal or unequal to a given width
and an optional tolerance defined by TRIGger:RUNT:WIDTh
and Runt Width
WITHin | OUTSide
Triggers on pulses inside or outside a given range. The range is
defined by ..
*RST: LONGer
TRIGger:PATTern:TIMeout[:TIME] <Time>
Sets a minimum time during which the signals match the pattern definition defined by
TRIGger:PATTern:STATe[:CHANnel<m>] and TRIGger:PATTern:STATe:
COMBination.
The command is required if TRIGger:PATTern:WIDTh:RANGe is set to TIMeout.
Parameters:
<Time> Range: 100E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger:PATTern:WIDTh[:WIDTh] <Duration>
Sets the width for comparison ranges LONGer, SHORter, EQUal and NEQual.
See TRIGger:PATTern:WIDTh:RANGe on page 319.
Parameters:
<Duration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger:PATTern:WIDTh:DELTa <Tolerance>
Sets a range Δt to the pattern width that is defined by TRIGger:PATTern:WIDTh[:
WIDTh].
Parameters:
<Tolerance> Range: 0 to 5000
Increment: 500E-12
*RST: 0
Default unit: s
Waveform Setup