Rohde & Schwarz Scope Rider RTH1004 - Page 404

Remote Control Commands
R&S
®
Scope Rider RTH
404User Manual 1326.1578.02 ─ 12
Return values:
<Result> Range: -100E+24 to 100E+24
Increment: 0
*RST: 0
Default unit: V
Example:
METer:INITiate
METer:FETCh?
<-- 999.98564109
Usage: Query only
15.8.5.2
METer:MEASure Commands
Sending a METer:MEASure:<function>? command is the same as sending the
METer:CONFigure:<function> command followed immediately by a READ? com-
mand.
METer<m>:MEASure:CURRent:AC?................................................................................404
METer<m>:MEASure:CURRent:DC?................................................................................404
METer<m>:MEASure:VOLTage:AC?................................................................................ 404
METer<m>:MEASure:VOLTage:DC?................................................................................ 404
METer<m>:MEASure:CURRent:AC? [<ExpectedValue>]
METer<m>:MEASure:CURRent:DC? [<ExpectedValue>]
Configures the current measurement and returns the result.
Suffix:
<m>
.
1..4
Selects the voltmeter.
Query parameters:
[<ExpectedValue>] <numeric value> | MIN | MAX | DEF
Optional parameter, expected measurement result or range. The
instrument sets the appropriate measurement range.
See: METer<m>:CONFigure:CURRent:DC.
Return values:
<Result> Numeric value
Usage: Query only
METer<m>:MEASure:VOLTage:AC? [<ExpectedValue>]
METer<m>:MEASure:VOLTage:DC? [<ExpectedValue>]
Configures the voltage measurement and returns the result.
Suffix:
<m>
.
1..4
Selects the voltmeter.
Voltmeter (R&S RTH1004)