Rohde & Schwarz Scope Rider RTH1004 - Page 403

Remote Control Commands
R&S
®
Scope Rider RTH
403User Manual 1326.1578.02 ─ 12
Usage: Event
15.8.5 Results
● Reading Values..................................................................................................... 403
● METer:MEASure Commands................................................................................404
● Statistics................................................................................................................405
15.8.5.1 Reading Values
METer<m>:INITiate........................................................................................................ 403
METer<m>:READ?.........................................................................................................403
METer<m>:FETCh?....................................................................................................... 403
METer<m>:INITiate
Resets the hardware and all statistical values, performs a single measurement and
ends in hold mode.
Suffix:
<m>
.
1..4
Usage: Event
METer<m>:READ?
Starts a new measurement, returns the current measurement result and stays in run
mode.
Suffix:
<m>
.
1..4
R&S RTH1002: always 1, omit the suffix
R&S RTH1004: Selects the voltmeter.
Return values:
<Meter result>
Usage: Query only
METer<m>:FETCh?
Returns the currently measured value.
Use this command after METer<m>:INITiate.
Suffix:
<m>
.
1..4
R&S RTH1002: always 1, omit the suffix
R&S RTH1004: Selects the voltmeter.
Voltmeter (R&S RTH1004)