Rohde & Schwarz Scope Rider RTH1004 - Page 407

Remote Control Commands
R&S
®
Scope Rider RTH
407User Manual 1326.1578.02 ─ 12
COUNter<m>:READ?..................................................................................................... 411
COUNter<m>:SENSe:FUNCtion...................................................................................... 411
COUNter<m>:SENSe:RANGe......................................................................................... 411
COUNter<m>:SENSe:REFerence:STATe..........................................................................411
COUNter<m>:SENSe:REFerence:VALue......................................................................... 412
COUNter<m>:SENSe:SOURce....................................................................................... 412
COUNter<m>:SENSe:STATe...........................................................................................412
COUNter<m>:SENSe:TRIGger:MODE.............................................................................412
COUNter<m>:ABORt
Aborts a running measurement and switches to single measurement mode.
Suffix:
<m>
.
1..2
Usage: Event
COUNter<m>:CALCulate:AVERage:ALL?
Queries the statistical results of all measured counter frequencies since statistics were
last restarted.
Suffix:
<m>
.
1..2
Return values:
<All statistics> Minimum, average, maximum value
Usage: Query only
COUNter<m>:CALCulate:AVERage:AVERage?
Queries the average of all measured counter frequencies since statistics were last
restarted.
Suffix:
<m>
.
1..2
Return values:
<Average> Average measured value
Range: -100E+24 to 100E+24
Increment: 1E-12
*RST: 0
Default unit: Hz
Usage: Query only
COUNter<m>:CALCulate:AVERage:CLEar
Resets all statistical values.
Counter Mode (R&S
RTH-K33)